 |
Settings |
Firmware Update
Updating the Firmware via Network
Preparation:
Check that the unit is turned on, and the connection to the Internet is secured.
Turn off the controller component (PC etc.) connected to the network.
Stop any playing Internet radio, USB storage device, or server content.
If the multi-zone function is active, turn it off.
If "HDMI CEC" is set to "On", set it to "Off".
–Press 
on the remote controller to display the Home screen. Next, select "System Setup" - "Hardware" - "HDMI", press ENTER, select "HDMI CEC" and select "Off".
＊The description may differ from the on-screen display but that will not change the way to operate or the function.
Update
1.Press 
on the remote controller.
The Home screen is displayed on the TV screen.
2.Select "System Setup" - "Miscellaneous" - "Firmware Update" - "Update via NET" with the cursors in order, then press ENTER.
If "Firmware Update" is grayed out and cannot be selected, wait for a while until it starts up.
You will not be able to select "Update via NET" if there is nothing to update.
3.Press ENTER with "Update" selected to start update.
During the update, the TV screen may go black depending on the updated program. In that case, check the progress on the display of the unit. The TV screen will remain black until the update is complete and the power is turned on again.
"Completed!" is displayed when the update is complete.
4.Press 
STANDBY/ON on the main unit to switch the unit to standby. The process is completed and your firmware is updated to the latest version.
Do not use 
on the remote controller.
If an Error Message is Displayed
When an error occurs, "＊-＊＊ Error!" is displayed on the display of the unit. ("＊" represents an alphanumeric character.) Check the following:
Error Code
＊-01, ＊-10：
Ethernet cable not found. Connect the Ethernet cable properly.
＊-02, ＊-03, ＊-04, ＊-05, ＊-06, ＊-11, ＊-13, ＊-14, ＊-16, ＊-17, ＊-18, ＊-20, ＊-21：
Internet connection error. Check the following:
–The router is turned on
–This unit and the router are connected via the network
Try to disconnect and then connect again the power to the unit and router. This may solve the problem. If you are still unable to connect to the Internet, the DNS server or proxy server may be temporarily down. Check the service status with your ISP provider.
Others
Disconnect then reconnect the AC power cord, then repeat from the beginning.
SN 29402604A HTML
(C) Copyright 2016 Onkyo & Pioneer Corporation Japan. All rights reserved.
